Toyota

2008 Toyota 4Runner

CRM Mitchell1 2022-05-25T21:59:44+00:00

Mileage

207,376

Service Date

5/16/2022

Services Performed

• Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and top off as necessary. Check belts, hoses and air up all tires to the correct psi.
• Customer was trying to change the oil and drained the transmission fluid.
• AUTOMATIC TRANSMISSION FLUID – Drain & Refill – Includes Check All Fluid Levels On Drive Line

 

Cindy C. gave our service a 5 star review on 5/23/2022

2008 Toyota 4Runner CRM Mitchell1 2022-05-25T21:59:44+00:00

2006 Toyota Sequoia

CRM Mitchell1 2021-12-02T23:02:09+00:00

Mileage

222,083

Service Date

11/30/2021

Services Performed

• The squeaky belt was most likely due to some contaminants such as coolant. Conditioner was applied to both sides of belt. Retest. The squeak is gone.
• Install Stud & Lug Nut

 

Ian N. gave our service a 5 star review on 12/1/2021

2006 Toyota Sequoia CRM Mitchell1 2021-12-02T23:02:09+00:00

2015 Toyota RAV4

CRM Mitchell1 2021-08-20T22:01:43+00:00

Mileage

39,599

Service Date

8/18/2021

Services Performed

• Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels, belts, hoses, and tire pressures.
• Diagnose – TPMS Light – They have aired up the tires to the correct pressure, but the light remains.
• Can we reattach the mirror shell?
• CABIN AIR FILTER – Remove & Replace
• BATTERY – Remove & Replace – [Includes: Test.]

 

Christy W. gave our service a 5 star review on 8/19/2021

2015 Toyota RAV4 CRM Mitchell1 2021-08-20T22:01:43+00:00

2015 Toyota Sequoia

CRM Mitchell1 2021-08-10T22:00:59+00:00

Mileage

101,564

Service Date

8/6/2021

Services Performed

• Includes installation of front premium brake pads, brake rotors and hardware as required. Clean and lubricate caliper slide mechanisms. Clean and repack wheel bearing if required. Adjust parking brake. Bleed and adjust brake system. Perform Relearn procedure if required.

 

Wes R. gave our service a 5 star review on 8/10/2021

2015 Toyota Sequoia CRM Mitchell1 2021-08-10T22:00:59+00:00

2006 Toyota Sequoia

CRM Mitchell1 2021-06-16T22:00:45+00:00

Mileage

215,556

Service Date

6/9/2021

Services Performed

• Diagnose – The vehicle blew a radiator hose and now the engine is clanging really loudly.
• RADIATOR – Remove & Replace
• RADIATOR HOSE – Remove & Replace – Both
• A/C COMPRESSOR DRIVE BELT – WARRANTY – Remove & Replace

 

Ian N. gave our service a 5 star review on 6/15/2021

2006 Toyota Sequoia CRM Mitchell1 2021-06-16T22:00:45+00:00

2010 Toyota Prius

CRM Mitchell1 2021-06-06T22:01:03+00:00

Mileage

152,157

Service Date

6/3/2021

Services Performed

• Diagnose – The brakes are not working. He believes that the brake booster or pump may be out. The vehicle was towed in.
• ANTI-LOCK BRAKE SYSTEM – Diagnosis
• Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. Replace the old fluid with a High Temp Formula BG Heavy Duty Brake Fluid, which is demoisturized to prevent corrosion.
• HYDRAULIC POWER BRAKE PUMP – Remove & Replace – [Includes: Calibration. Includes: R&I Subframe. DOES NOT include wheel alignment.] – [Includes: Bleed System.]
• MASTER CYLINDER – Remove & Replace – Hydraulic Booster Assembly – [Includes: Calibration.] – [Includes: Bleed Brake System. NOTE: Deduct .4 when used in conjunction with any other Brake operation(s).]
• Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.

 

Jeffrey E. gave our service a 5 star review on 6/5/2021

2010 Toyota Prius CRM Mitchell1 2021-06-06T22:01:03+00:00

2006 Toyota Sequoia

CRM Mitchell1 2021-06-04T22:00:44+00:00

Mileage

215,545

Service Date

5/12/2021

Services Performed

• TIE ROD &/OR END – Remove & Replace – Inner,Both – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing I
• Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.
• SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
• Includes installation of rear premium brake pads, brake rotors and hardware as required. Clean and lubricate caliper slide mechanisms. Clean and repack wheel bearing if required. Adjust parking brake. Bleed and adjust brake system. Perform Relearn procedure if required.
• Fix Trunk – The struts are not strong enough to hold it up. He thinks that it hit the lock too hard and now it won't open.
• TIMING BELT – Remove & Replace
• (Combination) – WATER PUMP – Remove & Replace
• Flush your vehicle's entire cooing system. Restore coolant and necessary additives. Install special conditioners to protect your car's cooling system. Recommended service interval: Every 2 years or 30,000 miles.
• VALVE COVER GASKET – Remove & Replace – Both
• We use a safe, powerful cleaner to dissolve and suspend varnish and deposits that form in your car's power steering system. Flush entire system of all old fluid and contaminants and install new high-tech fluid to protect against noise, wear and leakage in the system.
• Complete Fuel Induction Service Clean Fuel injectors. Clean Throttle body. Clean plenum and air intake system Recommended service internal: 35,000 Miles.
• SPARK PLUGS – Remove & Replace
• Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. Replace the old fluid with a High Temp Formula BG Heavy Duty Brake Fluid, which is demoisturized to prevent corrosion.
• TRUNK / LIFTGATE SHOCK OR STRUT – Remove & Replace – Both

 

Ian N. gave our service a 5 star review on 6/3/2021

2006 Toyota Sequoia CRM Mitchell1 2021-06-04T22:00:44+00:00

2010 Toyota Highlander

CRM Mitchell1 2021-04-17T22:01:12+00:00

Mileage

125,025

Service Date

4/13/2021

Services Performed

• Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. Replace the old fluid with a High Temp Formula BG Heavy Duty Brake Fluid, which is demoisturized to prevent corrosion.
• Check Brakes – When they are on the highway and brake the vehicle shakes.
• Includes installation of front premium brake pads, brake rotors and hardware as required. Clean and lubricate caliper slide mechanisms. Clean and repack wheel bearing if required. Adjust parking brake. Bleed and adjust brake system. Perform Relearn procedure if required.
• Includes installation of rear premium brake pads, brake rotors and hardware as required. Clean and lubricate caliper slide mechanisms. Clean and repack wheel bearing if required. Adjust parking brake. Bleed and adjust brake system. Perform Relearn procedure if required.

 

DALE J. gave our service a 5 star review on 4/16/2021

2010 Toyota Highlander CRM Mitchell1 2021-04-17T22:01:12+00:00

2006 Toyota Sienna

CRM Mitchell1 2020-06-16T22:01:27+00:00

Mileage

201,359

Service Date

6/11/2020

Services Performed

• Air Intake Bellow Tube – [Remove/Replace]
• Complete Fuel Induction Service Clean Fuel injectors. Clean Throttle body. Clean plenum and air intake system Recommended service internal: 35,000 Miles.
• Diagnose – At around 45 to 50mph it starts to shake.
• Diagnose – Check Engine Light
• Diagnose – Weird Idle
• Level 1 Diagnosis
• SPARK PLUGS – Remove & Replace – All Applicable Models – [Includes: R&I Upper Intake Manifold.]

 

Michelle D. gave our service a 5 star review on 6/13/2020

2006 Toyota Sienna CRM Mitchell1 2020-06-16T22:01:27+00:00

2012 Toyota Sienna

CRM Mitchell1 2020-04-18T22:00:21+00:00

Mileage

131,723

Service Date

4/15/2020

Services Performed

• * Install BG Advanced Formula MOA, a top-quality engine oil additive that fortifies the oil, providing for optimum engine performance and long-lasting engine protection. – Recommended Service Interval: Every 2 Years or 24,000 Miles Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels, belts, hoses, and tire pressures.
• BACKUP LIGHT BULB – Remove & Replace – Both
• Check Tail Lights
• Diagnose Check Engine Light.
• ENGINE PERFORMANCE – Analyze – All Applicable Models – [Includes: Check Ignition timing and Emission Control Systems using analyzer.]
• VARIABLE VALVE TIMING SENSOR – Remove & Replace – V6 Camshaft Position Sensor,Right Bank,Both – [Includes: R&I Upper Intake Manifold.]

 

Arthur G. gave our service a 5 star review on 4/17/2020

2012 Toyota Sienna CRM Mitchell1 2020-04-18T22:00:21+00:00